GBSM-34 Instruction Manual

INSTRUCTION MANUAL

INSTALLATION SCHEMATIC

 1 – FLAT GASKET                                                                                   2 – NUT                                                                                                       3 – BOLT                                                                                                     4 – SPRING GASKET                                                                             5 – FLAT GASKET                   

 6 – FLAT GASKET                                                                                   7 – BRACKET                                                                                           8 – BOLT                                                                                                   9 – NUT                                                                                                    10 – FLAT GASKET

11 – JOINT                                                                                              12 – FLAT GASKET                                                                                13 – NUT                                                                                                  14 – CONTROL BOX                                                                            15 – MOTOR

SETTINGS & FEATURES:

  1. Speed Setting: Speed is defined in Rotation per Minute (RPM) and appears on the screen when the motor is switched on. Press the【+】or【–】to increase or decrease the speed respectively. Release the button when you desired speed reaches on the screen, wait 1 second and the speed should be set. Seeing oE on the screen indicates that the speed has been set successfully.
  1. Rotation Direction Change Setting: To change the direction of rotation of themotor, long press【R】to enter the U Menu. Release it when U appears on the screen. Press【R】again to select from U0 – U8. For rotation change, reach the U2 setting and change the value from 0 to 1 or vice versa by pressing【+】or 【–】

                             0 = Clockwise rotation                                                                                                                                           1 = Anticlockwise rotation

                Wait for oE to appear on the screen, then the parameter is set successfully.

            3. Needle Position Setting: If a synchronizer is installed, you may set the Needle                         Position by pressing 【N】once (single click); the screen should then display                         info on the position of the needle that’s currently set:                                                                                        UP = Needle stays in up position                                                                                                                      DN = Needle stays in down position

Note: The synchronizer device must be attached to the controller to use this feature.

Restore to Factory Settings: Long press【N】for 5 seconds to reset the controller to factory settings. Release the button when oE appears on the screen, then the controller should be reset to factory settings.

COMMON PROBLEMS AND THEIR SOLUTIONS: 

  • Err1: This error appears on screen when the motor is having huge difficulty in rotation. Motor will not work. To fix it, restore it to factory settings as shown above.
  • Err2: This error occurs when there is high/low voltage or high/low flow of current through the circuit. Check your voltage and power source if it is high or low then restore it to the factory settings. 
  • Err4: Happens when cords are not connected properly. Check if all wires are well connected. Another possibility, there may be a fault in the hall sensor device in the motor. Check all connections, secure the circuit and restore them to the factory settings. If the problem persists then please send it for repair. Do NOT open the case of the servo-motor or reveal any live electric wires for any reason!
Shopping Cart